Adaptec AHA-2930CU Installation Guide download pdf (Page 29)

Installing device drivers 21

VIDAR Film Digitizer Installation Guide

2. Use the SCSI utility to configure the SCSI BIOS

In most cases, the digitizer is not properly detected after you install the

SCSI adapter. This is because the computer tries to boot from the

adapter, but no SCSI hard disk is connected. You must correct this

behavior in the SCSI BIOS.

a. Turn on the computer.

b. When the computer boots up, it will detect the SCSI Adapter. When

prompted, press <Ctrl A> to access the SCSI Utility.

c. In the Options menu (see below), select the Configure/View Host

Adapter Settings option.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

No comments

Adaptec AHA-2930CU Installation Guide Page 29