Adaptec AHA-2930CU Installation Guide download pdf (Page 21)

Setting up 13

VIDAR Film Digitizer Installation Guide

Connect the SCSI cable

For best performance, use the shielded SCSI cable available from

VIDAR (part number 4137-001).

Note: Attach or remove the SCSI cable carefully to avoid

bending the connector pins. Insert the connector straight into

the SCSI port. Inserting the connector at an angle may damage

the pins. If the pins or cable are damaged, improper SCSI

operation may result.

Note: Before connecting the SCSI cable, be certain that the

SCSI cable isn’t connected to anything else and the digitizer

power supply is unplugged.

1. Carefully attach the SCSI connector to the one of the film digitizer’s

SCSI ports. Apply even pressure to avoid bending SCSI connector

pins. Do not force the connectors together.

SCSI ID switch

ort connectors

SCSI termination

switches

2. Connect the other end of the cable to the SCSI port on the computer.

WARNING: If the SCSI connector has bent pins, it will damage

the SCSI port in the digitizer. Do not attempt to straighten bent

pins. Discard any SCSI cable with bent pins and replace it with

a new cable.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

No comments

Adaptec AHA-2930CU Installation Guide Page 21