Adaptec AHA-2930CU Installation Guide download pdf (Page 14)

6 Unpacking

VIDAR Film Digitizer Installation Guide

Repacking the film digitizer

IMPORTANT: When shipping the film digitizer, you must use the original packing

materials, including plastic bags, foam supports and carton. Improper packaging may

allow damage to the digitizer, which will incur additional charges for repair.

CAUTION: To prevent personal injury and damage to the digitizer, two people are

needed to repack the digitizer.

1. Place the digitizer and film feeder in separate plastic bags (not shown here for clarity),

and seal the bags.

2. Place one foam support on the digitizer. Note the digitizer’s orientation: front is up.

3. Place the other foam support on the digitizer.

4. Slide the film feeder into the slots near the top of the foam supports.

5. Gently lower the assembly into the carton.

6. Close and securely tape the carton.

IMPORTANT: You must

include the film feeder.

The unit cannot be properly

repaired without its film

feeder.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

No comments

Adaptec AHA-2930CU Installation Guide Page 14