Adaptec 1742A User Manual

_ FCO PB22H-O002, ADAPTEC 1742A not compatible with OSF/1______________________________________________________________________________ | DIGITAL

| FCO CHARGING INFORMATION (See Last Page) ||_____________________________________________________________________

 once they have been lost. To record the bootstrap settings, from  the ’setup menu’ select the ’manage boot selection menu’ then  select

* being upgraded. * ********************************************************************

2. Loosen the two screws securing the large (lower) inside cover to the chassis, (toward the front of the box). 3. By inserting yo

1. Position the module on a clean and dry area with the connector fingers pointing away from you. Locate the EPROM U10 at the right of the  m

* * * If using a module in an ESD box, insure wrist strap is connected *

 Model 300 AXP Hardware Service Information Manual, Order No.  EK-A0637-SV. This manual is also on TIMA in the Tools section. 16. Set the NT

______________________________________________________________________________| FCO CHARGING INFORMATION