Adaptec 39160 Installation Guide download pdf (Page 16)

Adaptec SCSI Card 39160 User’s Reference

Common Error Messages

Here is what you should do if the following messages appear on the

screen at bootup:

“Device connected, but not ready”

The host computer received no answer when it requested data from

an installed SCSI device.

Run SCSI

Select

and set the Send Start Unit Command to

Yes

for the particular SCSI device ID. See

Starting SCSISelect

page 18.

Ensure that the device is set to spin up when the power is

switched on. The spin up option is typically set by a jumper.

(See the documentation for the device.)

“Start unit request failed”

The SCSI card BIOS was unable to send a Start Unit Command to

one of the installed SCSI devices. Run SCSI

Select

and disable the

Send Start Unit Command for the device.

“Time-out failure during...”

An unexpected time-out occurred.

Verify that the SCSI bus is properly terminated.

Verify that all cables are properly connected.

Try disconnecting the SCSI device cables from the SCSI card and

then starting the computer. If the computer successfully restarts, one

of the SCSI devices may be defective.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

No comments

Adaptec 39160 Installation Guide Page 16