Adaptec AVA-2906 Installation Guide download pdf (Page 11)

SCSI Card 2906

Connecting Internal SCSI Devices

Be sure that each internal SCSI device you are installing has a

unique SCSI ID from 0 to 6. Refer to the SCSI device’s docu-

mentation to determine the SCSI ID setting.

If any two SCSI devices (internal or external) you are connect-

ing to the SCSI card have the same SCSI ID, change the SCSI ID

on one SCSI device. The SCSI Card 2906 is preset to SCSI ID 7

and should not be changed. See the SCSI Card 2906 User’s Ref-

erence for additional information on SCSI IDs.

If you are installing one internal SCSI device only, terminate

that SCSI device. If you have two or more internal SCSI

devices, terminate the device that will be connected at the end

of the cable.

For more information on termination, refer to the SCSI device’s

documentation or the section titled Terminating the SCSI Bus in

the SCSI Card 2906 User’s Reference.

Mount each internal SCSI device in an available drive bay

inside your computer as shown in the following diagram.

Refer to your computer and SCSI device documentation for

instructions on installing SCSI devices inside your computer.

Internal SCSI Device Mounted

in Drive Bay Inside Your Computer

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Adaptec AVA-2906 Installation Guide Page 11