Adaptec PCI Ethernet and Fast Ethernet Adapters User's Guide download pdf (Page 49)

6-3

UNIX

SCO UnixWare

This section describes how to install LAN drivers for UnixWare. The

driver for this operating system is located on Diskette 1 in the

/UNIXWARE

directory.

The SCO UnixWare driver supports up to four ports for the same

type of NIC. It does not support a mixture of NICs at the same time.

Note:

All commands in Unix are case sensitive. Be sure to

type all commands exactly as shown.

Removing Previously Configured Drivers

Before adding the Adaptec NIC you must first remove any previous

driver package, then reinstall it for the new NIC.

As the root user, remove the package by typing pkgrm EMPCI.

Follow the online prompts to remove the package.

Shut down the system, replace the NIC and reboot.

Adding NIC Drivers

After booting up with UnixWare, press contrl/alt/sys rq and

then P to go to the system command line prompt.

Insert Diskette 1 in drive A. To copy the compressed driver file

from the floppy drive to the local hard disk, type

doscp a:/unixware/EMPCI.Z /tmp/EMPCI.Z

To uncompress the file type

uncompress /tmp/EMPCI

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 121 122

No comments

Adaptec PCI Ethernet and Fast Ethernet Adapters User's Guide Page 49