Adaptec AHA-3985 User's Guide download pdf (Page 14)

1-2

AHA-3980/3980W/3985/3985W User’s Guide

Stock Number: 510810-00, Rev. D Page: 1-2

Print Spec Number: 493479-00

Current Date: 3/1/99 ECN Date: 3/19/96

The CI/O software allows you to monitor and manage the network

from remote workstations.

System Requirements

The AHA-398x RAID adapter and software must be installed on a

NetWare server that has the following system resources:

Hardware/Firmware

■

An 80486DX or Pentium computer that complies with PCI

Rev. 2.0

■

A motherboard BIOS that supports PCI-to-PCI bridges, a

64-KByte BIOS, and multiple interrupts

If you are not sure which features the BIOS supports, contact

your vendor, or call Adaptec’s Interactive Fax Service for a list

of compatible motherboards. See

Adaptec Technical Support and

Services

on page ii.

■

An available full-length PCI slot that supports bus mastering

and PCI Int B

■

A 3.5-inch 1.44-MByte primary (boot) floppy disk drive

■

A minimum of two SCSI disks for a RAID 0 or mirrored array;

a minimum of three SCSI disks for a RAID 0 CVT, RAID 5, or

RAID 5 CVT array (see

Number of Disks in an Array

on page 2-3)

■

Two MBytes of hard disk space for the Adaptec RAID software

Software

■

NetWare 386, version 3.11, 3.12, or 4.xx

■

NetWare CLIB 3.12 or higher

■

MS DOS 5.0 or above (MS-DOS 6.0 or above recommended)

■

The

Adaptec Initial Array Configuration Utility

and

AHA-3980/

3985 Drivers and RAID Utilities

diskettes, which are included

with the AHA-398x

■

To run CD-ROM drives under MS-DOS 5.0: The Microsoft

CD-ROM extension,

mscdex.exe

, which is included with

MS-DOS 6.0 or above. (This file is also available on Microsoft’s

electronic bulletin board)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 165 166

Comments to this Manuals

No comments

Adaptec AHA-3985 User's Guide Page 14

Comments to this Manuals

Related products and manuals for System management software Adaptec AHA-3985