Adaptec 2940U2W Instruction Manual download pdf (Page 23)

Configuring the SCSI Card 2940U2W with SCSISelect

Note:

If you have difficulty viewing the display, press F5 to

toggle between color and monochrome modes. (This feature

may not work on all monitors.)

Exiting SCSI

Select

Follow these steps to exit SCSISelect:

Press Esc until a message prompts you to exit (if you changed

any settings, you are prompted to save the changes before you

exit).

At the prompt, select Yes to exit, then press any key to reboot

the computer. Any changes you made in SCSISelect take effect

after the computer boots.

Using SCSI

Select

Settings

To select an option, use the ↑ and ↓ keys to move the cursor to the

option, then press Enter.

In some cases, selecting an option displays another menu. You can

return to the previous menu at any time by pressing Esc.

To restore the original SCSISelect default values, press F6 from the

main SCSISelect screen.

Basic Host Adapter Settings

■

Host Adapter SCSI ID—Sets the SCSI ID for the SCSI card.

The SCSI Card 2940U2W is set at 7, which gives it the highest

priority on the SCSI bus. We recommend you do not change

this setting.

■

SCSI Parity Checking—When set to Enable, verifies the accu-

racy of data transfer on the SCSI bus. Leave this setting

enabled unless any SCSI peripheral connected to the SCSI Card

2940U2W does not support SCSI parity.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

No comments

Adaptec 2940U2W Instruction Manual Page 23