Adaptec 2940U2W Instruction Manual download pdf (Page 15)

Troubleshooting

Common Error Messages

The following messages may appear at bootup:

“Device connected, but not ready”

The host received no answer when it requested data from an

installed SCSI peripheral.

■

Run SCSISelect

and set the Send Start Unit Command to Yes

for the particular SCSI peripheral.

■

Make sure the drive is set to spin up when the power is

switched on. (See the documentation for the peripheral.)

“Start unit request failed”

The SCSI Card BIOS was unable to send a Start Unit Command to

the peripheral.

■

Run SCSISelect and disable the Send Start Unit Command for

the peripheral.

“Time-out failure during...”

An unexpected time-out occurred.

■

Verify the SCSI bus is properly terminated.

■

Verify all cables are properly connected.

■

Try disconnecting the SCSI peripheral cables from the SCSI

card and then starting the computer. If the computer

successfully restarts, one of the SCSI peripherals may be

defective.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

No comments

Adaptec 2940U2W Instruction Manual Page 15