FAQ’s for Actel’s Antifuse FPGA Programming 7
Failure codes are:
Three short flashes-- cannot self-calibrate
Two short flashes -- ROM checksum error
One short, one long flash-- RAM error
If you encounter an
y of these errors
, contact Actel Tec
hnical Support
tech.s[email protected]. Do not
attempt to program any devices if POST fails.
4. Does the Silicon Sculptor programmer have any memory? Does it retain
any programming data after the programming?
Ans. Yes. Memory is used to broadcast the programming information in concurrent mode. As soon as the
programmer is powered down, no design content remains in the memory components.
Refer to the non-volatility certificate available at:
www.actel.com/documents/Memory_SiliconScultor_CL.pdf for more information.
5. Where can I find a list of adapter module part numbers for Silicon
Sculptor?
Ans. The adapter modules are device, package, and programmer specific. The list of modules for Silicon
Sculptor is available at: www.actel.com/products/hardware/program_debug/ss/modules.aspx.
You can also get the module information from the SculptW software: Device > Device Info and Device >
Socket Module Info
Figure 1: Socket Module Info Window
Comments to this Manuals