Adaptec 2940UW Installation Guide download pdf (Page 9)

AHA-2940/2940W Installation Guide

Part Number: 510881-00, Rev. A

Print Spec Number: 493890-00

Current Date: 7/5/95 ECN Date: 7/11/95

For situations where you might want or need to

change the settings, see the descriptions of each set-

ting in the user’s guide. If you need to change any of

the default settings, or if you would like to format or

verify a disk, see Starting the SCSISelect Utility on

page 9 to start the utility.

Applies to AHA-2940 only

Applies to AHA-2940W only

Setting is valid only if Multiple LUN Support is enabled

Settings are valid only if host adapter BIOS is enabled.

Basic Host Adapter Settings Default

Host Adapter SCSI ID 7

SCSI Parity Checking Enabled

Host Adapter SCSI Termination Automatic

;

Low ON/

High ON

Boot Device Settings Default

Boot Target ID 0

Boot LUN Number

SCSI Device Settings Default

Initiate Sync Negotiation Yes (Enabled)

Maximum Sync Transfer Rate 10 MBytes/sec

Enable Disconnection Yes (Enabled)

Initiate Wide Negotiation

Yes (Enabled)

Send Start Unit SCSI Command

No (Disabled)

Advanced Host Adapter Settings Default

Plug and Play SCAM Support Disabled

Host Adapter BIOS Enabled

Support Removable Disks Under BIOS as Fixed Disks

Boot only

Extended BIOS Translation for DOS Drives > 1 GByte

Enabled

Display <Ctrl-A> Message During BIOS Initialization

Enabled

Multiple LUN Support

Disabled

BIOS Support for More Than 2 Drives

Enabled

BIOS Support for Bootable CD-ROM

Enabled

BIOS Support for Int 13 Extensions

Enabled

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Adaptec 2940UW Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Serial switch boxes Adaptec 2940UW