Adaptec 2940UW Installation Guide Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
13
AHA-2940/2940W Installation Guide
Part Number: 510881-00, Rev. A
Print Spec Number: 493890-00
Current Date: 7/5/95 ECN Date: 7/11/95
FCC Compliance Statement
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These lim-
its are designed to provide reasonable protection against harmful interfer-
ence in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause interference to radio or television equipment
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Move the equipment away from the receiver
Plug the equipment into an outlet on a circuit different from that to
which the receiver is powered
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions
CAUTION: Only equipment certified to comply with Class B (computer
input/output devices, terminals, printers, etc.) should be attached to this
equipment, and must have shielded interface cables.
Finally, any changes or modifications to the equipment by the user not
expressly approved by the grantee or manufacturer could void the user's
authority to operate such equipment.
Each host adapter is equipped with an FCC compliance label which shows
only the FCC Identification number. The full text of the associated label
follows:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Adaptec, Inc.
691 South Milpitas Blvd.
Milpitas, CA 95035
Copyright © 1995, Adaptec, Inc. All rights reserved. Adaptec, the
Adaptec logo, AHA, EZ-SCSI, and SCSISelect are trademarks of
Adaptec, Inc. which may be registered in some jurisdictions. All
other trademarks are owned by their respective owners.
Printed in Singapore
Stock No.: 510881-00, Rev. A RQ 7/95
Information subject to change without notice.
Page view 13
1 2 ... 9 10 11 12 13 14

Comments to this Manuals

No comments