Adaptec GDT RN Series Service Manual download pdf (Page 41)

Sun Storage Common Array Manager Software Release Notes 37

Solaris Issues

Error--”no execute access to opt/SMgr/agent/notifysmagent.sh”-- occurs

during system boot-up

Bug 6934913 –This error occurs when /opt(SMagent install directory) is built on a

disk partition other than root partition. Though event notification is lost as a result,

there are no adverse effects because the SMagent detects the disk device(UTM

volume) during re-scan. The notifysmagent.sh script should be available to the

syseventd since the script is located in the same directory of SMagent startup script.

Solaris runtime and RAID array proxy agent packages install on wrong

architectures

Bug 6665774 –If you perform installation using the incorrect package, Sun Storage

Common Array Manager installs but does not run. For example, if the in-band proxy

agent packages are being delivered as architecture-dependent (SPARC and x86 for

Solaris), then the SPARC package installation should not succeed on an x86

platform. The risk of this happening is low.

Workaround –Install the correct package. See the Sun Storage Common Array Manager

Software Installation and Setup Guide for instructions.

Solaris Target Port Group Support (TPGS) not supported

Bug 6872689 –Solaris Target Port Group Support (TPGS) is not a supported host type

at this time. Do not select this host type until Solaris provides the necessary support.

Upgrading Solaris to version 10 or higher might disable Oracle Java Web

Console connections

After performing the upgrade, open port 6789 for incoming connections:

1. Check current status of port 6789:

#netstat -an | grep 6789

Typical output is: *.6789 *.* 0 0 49152 0 LISTEN

2. Enable port 6789:

# svccfg -s svc:/system/webconsole setprop options/tcp_listen = true

# smcwebserver restart*

1 2 ... 36 37 38 39 40 41 42

No comments

Adaptec GDT RN Series Service Manual Page 41