Adaptec AHA-2740-T User Manual download pdf (Page 5)

FCC Compliance Statement

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in residential

installations. This equipment generates, uses, and can radiate radio frequency

energy, and if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause interference to radio or television equipment reception,

which can be determined by turning the equipment off and on, the user is encour-

aged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

•

Move the equipment away from the receiver

•

Plug the equipment into an outlet on a circuit different from that to

which the receiver is powered

•

If necessary, the user should consult the dealer or an experienced

radio/television technician for additional suggestions

CAUTION: Only equipment certified to comply with Class B (computer input/output

devices, terminals, printers, etc.) should be attached to this equipment, and must

have shielded interface cables.

Finally, any change or modifications to the equipment by the user not expressly

approved by the grantee or manufacturer could void the user’s authority to operate

such equipment.

Each AHA-2740 Series host adapter is equipped with an FCC compliance label

which shows only the FCC identification number. The full text of the associated label

follows:

This device complies with part 15 of the FCC rules. Operation is subject to the follow-

ing two conditions: (1) this device may not cause harmful interference and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

Adaptec AHA-2740 Series User’s Manual

Stock Number: 510381-00 / Rev. C (Page 0-iii)

Print Spec Number: 491709-00 Rev C

Current Date: 9/1/93 ECN Date: 9/14/93

iii

1 2 3 4 5 6 7 8 9 10 ... 132 133

No comments

Adaptec AHA-2740-T User Manual Page 5