Adaptec ASR-6405E User's Guide download pdf (Page 79)

Chapter 10: Solving Problems ● 79

4 Power off your computer, disconnect the power cord, then open the cabinet following the

manufacturer’s instructions.

5 Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0

flash connector.

Note:

To locate the Mode 0 flash connector on your Adaptec RAID controller, see the

figures in

About Your RAID Controller

on page 17. On Adaptec Series 6/6E controllers, the

label on the flash connector is “HDA mode.”

Reconnect the power cord, power on your computer, then boot to the drive containing the

AFU.exe file (see Step 3).

7 At the prompt, type

<drive-letter>:\afu update /c x

where

drive-letter

is the drive identifier (

for a floppy drive, for instance) and

is the

controller number.

Note:

You will be prompted to insert other disks, as needed.

When the flash is complete, power off your computer, disconnect the power cord, then

remove the jumper.

9 Close the computer cabinet, reconnect the power cord, then power on your computer.

The controller should boot correctly.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 144 145

No comments

Adaptec ASR-6405E User's Guide Page 79