Adaptec 3940AUW Installation Guide Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
3
AHA-3940AU/AUW Installation Guide
Part Number: 511418-00, Rev. A
Print Spec Number: 496346-00
Current Date: 3/12/97 ECN Date:3/10/97
Default Settings
AHA-3940AU/AUW host adapters operate cor-
rectly with their factory default settings in most com-
puters with PCI slots. The following table lists the
settings and their default values. You can change
these settings with the SCSISelect utility. (See
Configuring the Host Adapter on page 8.)
1. Setting is valid only if Multiple LUN Support is enabled.
2. Default Setting for the AHA-3940AU is 10 MBytes/sec.
Default Setting for the AHA-3940AUW is 20 MBytes/sec.
3. Ultra speed for the AHA-3940AU is 20 MBytes/sec.
Ultra speed for the AHA-3940AUW is 40 MBytes/sec.
4. AHA-3940AUW only
5. Settings are only valid if channel BIOS is enabled.
SCSI Bus Interface Definitions Default Setting
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Termination Automatic
Boot Device Settings Default Setting
Boot Channel A First
Boot SCSI ID 0
Boot LUN Number
1
0
SCSI Device Configuration Default Setting
Initiate Sync Negotiation Yes (Enabled)
Maximum Sync Transfer Rate 10 MBytes/sec
2
,
3
Enable Disconnection Yes (Enabled)
Initiate Wide Negotiation
4
Yes (Enabled)
Send Start Unit Command
5
No (Disabled)
BIOS Multiple Lun Support
5
No (Disabled)
Include in BIOS Scan Yes (Enabled)
Advanced Configuration Options Default Setting
Plug and Play SCAM Support Disabled
Reset SCSI Bus at IC Initialization Enabled
Extended BIOS Translation for DOS Drives > 1 GByte
5
Enabled
Host Adapter BIOS (Configuration Utility Reserves BIOS
Space)
Enabled
Support Removable Disks under BIOS as Fixed Disks
5
Boot Only
Display <Ctrl-A> Message During BIOS Initialization
5
Enabled
BIOS Support for Bootable CD-ROM
5
Enabled
BIOS Support for Int 13h Extensions
5
Enabled
3
Page view 3
1 2 3 4 5 6 7 8 9 ... 13 14

Comments to this Manuals

No comments