RAdaptec ACS-120USB 2.02.5” Hard Disk DriveEnclosureUser’s Guide
9Connecting and Powering OnNote: Windows 98SE users only—You must install the device drivers before connecting and powering on the enclosure.Plug the
10Connecting the USB Y-Cable to a Second USB 2.0 PortIf you have another available USB port on your computer (does not have to be a USB 2.0 port), plu
11Next StepsIf you have installed a new disk drive in your enclosure, you must prepare it for use by initializing and formatting it, so that your comp
12Disconnecting Your USB EnclosureAlthough the enclosure supports hot-plugging and hot-unplugging, Adaptec recommends that you follow these instructio
13TroubleshootingIf you have problems installing or using your Adaptec ACS-120 USB Enclosure, work through this list of suggestions: Ensure that the
14 Windows 98SE users—If you connected and powered on your USB Enclosure before you installed the device drivers:a On your desktop, right-click My Co
RAdaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USA©2005 Adaptec, Inc.All rights reserved. Adaptec and the Adaptec logo are trademarks of
1Copyright©2005 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
2Limited 1-Year Hardware Warranty1. Adaptec, Inc. (“Adaptec”) warrants to the purchaser of this product that it will be free from defects in material
3Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this uni
4In this Guide...This User’s Guide explains how to install and connect your Adaptec® ACS-120 USB 2.0 hard disk drive enclosure.Kit Contents 5Supported
5Kit Contents Adaptec ACS-120 USB 2.0 hard disk drive enclosure (shown below) High-quality USB Y-cable (shown below) Carrying case Bag of screws
6System RequirementsTo successfully install and use your Adaptec ACS-120 USB Enclosure, your computer must meet these requirements: Microsoft® Window
7Preparing the Disk Drive for InstallationBefore installing the disk drive, ensure that it meets the requirements listed in Supported Disk Drives on p
83 Slide the disk drive into the enclosure, then use the screws you removed in Step 1 on page 7 to secure the enclosure cover, as shown below.Installi
Comments to this Manuals