Adaptec Storage Manager User Manual download pdf (Page 76)

Chapter 9: Managing Logical Drives and Hot Spares ● 75

Creating Logical Drives

For basic instructions for creating logical drives, see Step 4: Building

Your Storage Space on page 47.

This section describes three additional scenarios for creating logical

drives:

● Setting the size of a new logical drive (see below)

● Including different-sized disk drives in a logical drive (see page 76)

● Creating a logical drive using available segments of disk drives (see

page 77)

Setting the Size of a Logical Drive

As described in Step 6 on page 53, Adaptec Storage Manager

automatically sets the size of a new logical drive to maximize the

capacity of the disk drives that it comprises. However, you can choose to

set the size for a new logical drive. You may want to do this to maximize

your available disk drive space, or allocate available space to more than

one logical drive.

To set the size of a logical drive,

1 Complete Steps 1 through 6 in Custom Configuration (Advanced) on

page 51.

2 Click Advanced Settings.

The maximum size of the logical drive appears in the Size (GB) box.

3 Enter the new size for the logical drive. The size you enter must be

less than or equal to the maximum size.

4 Click Next.

5 Review the logical drive settings, click Apply, then click Ye s .

Adaptec Storage Manager builds the logical drive. The configuration

is saved in the Adaptec controller and in the physical drives.

If the disk drives you used to create this logical drive have available

space left over, you can use them to create a new logical drive (see

page 77), or to expand an existing logical drive (see page 84).

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 190 191

No comments

Adaptec Storage Manager User Manual Page 76